KSWK Recessed Wall Kit for Quiet-One 2000 Series Kickspace Heaters

The KSWK Quiet-One 2000 recessed wall kit continues the tradition of supplying flexible solutions for those hard to heat areas. These wall kits can mount in any wall of the house. It can also be used in ceiling applications, or be installed in the end of cabinets or bathroom vanities. They can be used in dressing rooms, walk-in closets or in mud rooms and entry ways.

The cover is painted with a high grade primer finish which may be used as is or can be painted, papered or marbleized.

Recessed Wall Kit ONLY this Kit must be combined with the proper Quiet-One 2000 model kickspace heaters

The KSWK Quiet-One recessed wall kits have been designed to accept Quiet-One 2000 model kickspace heaters. The KSWK Wall Kit accepts the KS2004, KS2006 and KS2008 kickspace heaters, while the KSWK2010 must be used with the KS2010 heater.

Buyers please note: Kits and kickspace heaters must be purchased separately.

KSWK Recessed Wall Kit Features:

• The KSWK recessed wall kit accepts either the Quiet-One 2000 KS2004, KS2006, or KS2008 kickspace heater.
• Whisper quiet efficient operation.
• Easily mounted between 16" O.C. Studs.
• Attractive grille design.
• Two position speed switch
• (Max.-Off-Min.) hidden behind access door.
• Water vent easily accessible for venting air.

KSWK Recessed Wall Kit Specifications:

Construction. The one piece KS chassis and grille is manufactured from high grade zinc coated steel. The grille is 31⁄6" wider and 31⁄2" longer than the chassis in order to cover the wall opening while allowing room to sweat the S & R copper.

Heat Exchanger. A highly efficient, headered coil, made of copper tubes expanded into smooth aluminum plate fins (10 FPI), tested at 300 PSI, and sealed for quality. The heat exchanger is positioned in the kickspace for maximum heat transfer over the coil.

Fan and Motor Assembly. High spec tangential SEL fan and motor assembly consists of high static fan wheel and scroll, detachable motor, replaceable “easy glide” sleeve bearings, and the fan and motor cut out are protected to UL/CSA specifications. This fan and the motor assembly is designed to enhance the “coanda” effect, and to run whisper quiet without vibration.

Controls. The KS units have integral two speed, max.-off-min., fan switches (optional wall mounted fan speed controller is available). The LTC – low limit aquastat is also a high spec item with a close tolerance designed to close on a rise to 130 F+/-3 F and open at 110 F+/-3 F. For low temperature systems you will have to change out the aquastat located in the main electrical box easily removed from its hold on clip.

Water Connections. Supply and return connections are 1⁄2" sweat connections located to the right of the unit as you face the grille. A water vent with wide convenient screwdriver slot is accessible through the grille.

Electrical Connections. 120/60/1 power supply is required. All that’s required is to knock out the junction box hole you want to use and wire to the L1 and L2 leads. There is a convenient one screw access plate on the top of the unit to get at the ground.

Additional Documentation for the KSWK Recessed Wall Kit:

Color Brochure
Submittal Sheet