Hartell #SC-1A, High Temperature Reservoir Pump

SC-1A high temp, high capacity, & high performance reservoir pump, The Model SC-1A, may also be used for commercial - high temperature condensate removal.

SC-1A Series Pumps are designed expressly for automatically returning condensate to a collection point where radiation has been
added to existing systems below the returns. Rated for 2000 EDR; 480000 BTU
· Vapor sealed, cast aluminum reservoir.
· Integral junction box.
· Steam rated for 2000 EDR, 480000 BTU.
· Usable lifts over 40 ft.
· Dual voltage motor.
· Heavy duty design for industrial applications.
· One year warranty.
· Allows condensate removal without having floor drains.

SC-1A   is a high temp, high capacity, & high performance reservoir pump or for use as a commercial condensate removal pump. 43 Foot Head - 4 Gallon Aluminum Reservoir - STEAM CONDENSATE (to 212º F) Rated for 2000 EDR; 480000 BTU. - 1 Year Warranty. Designed expressly for automatically returning condensate to a collection point where radiation (heat) has been added to existing systems below the returns.

 Steam Condensate Pump - High Temperature, High Capacity & High Performance Reservoir Pump for Commercial Steam Condensate Removal

   *** AUXILIARY SAFETY SWITCH it is strongly recommends that all installations include a properly wired auxiliary safety switch. The auxiliary safety switch will shut down the appliance in the event of a pump overflow condition that could lead to property damage. Pump overflow can be caused by a blocked discharge line, power loss to the pump, or pump malfunction. The switch can be wired in-line with the thermostat to shut down the appliance; or wired directly to an alarm. Hartell models followed by the letter “X” include the auxiliary safety switch

 ------------------------------------------------------------------------------------------------

For Your Information: ABOUT CONDENSATE PUMPS 

GENERAL INFORMATION ABOUT TYPICAL CONDENSATE PUMP APPLICATIONS

  AUXILIARY SAFETY SWITCH it is strongly recommends that all installations include a properly wired auxiliary safety switch. The auxiliary safety switch will shut down the appliance in the event of a pump overflow condition that could lead to property damage. Pump overflow can be caused by a blocked discharge line, power loss to the pump, or pump malfunction. The switch can be wired in-line with the thermostat to shut down the appliance; or wired directly to an alarm. Hartell models followed by the letter “X” include the auxiliary safety switch

Condensate is produced at a rate of up to a gallon per hour by a residential central air conditioning unit or gas condensing furnace. The installer will feed the condensate from the appliance drain into one of the pumps inlet ports. Hartell condensate pumps are equipped to connect with 3/8" ID plastic tubing. The tubing is connected to the pump check valve, leading to a drain line, sump, French drain or sink.

The "Lift" or "Head" of the pump refers to the height the pump is required to "lift" the water up to the drain. The distance the water needs to travel horizontally once the lift is achieved is referred to as the "Run". The "run" does not effect the lift or flow rate of the pump unless it exceeds 50 feet. "Runs" of 50' or more will decrease pump output by about 10%.

Hartell Condensate Pumps are perfect for use as wastewater drain pumps for ice makers, beverage dispensers, drinking fountains, water coolers, dehumidifiers and high efficiency heating and air conditioning equipment. Let us help you select the model you need for your project.