Sump Pump by Little Giant 'Big John' #6-CIA (506158)

For residential and light commercial use, the Model 6 Series sump pumps provide efficient and reliable service. For extended or continuous use in moving large volumes of water, these pumps feature a 1-1/2" discharge with a maximum lift of 18', a polycarbonate cover and a polypropylene volute/base. The Little Giant 'Big John' 6-CIA Submersible Cast Iron Sump Pump is fully automatic.

Little Giant 6 series Sump Pump: 1/3HP Submersible Sump Pump with cast iron housing, polypropylene base, polycarbonate cover, and thermal overload protection. "CIA" models have integral diaphragm switch with "on" level at 7" to 10" and "off" level at 1" to 4".

Sump Pump #6-CIA (506158) Features & Specifications

Little Giant 'Big John' 6-CIA Features:

• Cast iron pump housing with protective epoxy coating for corrosion resistance
• Oil-filled motor housing for lifetime lubrication and rapid heat dissipation
• 1/3 HP shaded pole motor
• Stainless steel screws, bolts and handle to protect against corrosion
• Mechanical seal (stainless steel spring, nitrile parts, carbon and ceramic faces) to assure maximum protection against pump failure
• Bearings: Upper and lower sintered sleeve bearings for extended motor life
• Thermal overload protection
• Manual and automatic models
• Automatic operation with pressure switch activates pump when water level is between 7" and 10". Pump shuts off when water level falls to between 1" and 4" (pressure switch is non-adjustable)
• Automatic operation with piggyback mechanical float switch activates pump when water level is between 9" and 10-1/2". Pump shuts off when water level falls to between 2" and 3" (pumping range is adjustable)
• 115 volt models

Little Giant 'Big John' 6-CIA /  #506158, Specifications:

• Model Number - 6CIA
• Item Number - 506158
• Volts - 115
• Hertz - 50/60
• Horsepower - 1/3
• Cord Length - 8'
• 1-1/2 discharge
• GPM at 5' - 46
• Maximum lift of 18 feet
• Certification - UL/CSA

Little Giant 'Big John' 6-CIA Construction Specifications:

• Cover - Polycarbonate
• Motor Housing - Epoxy Coated Cast Iron
• Impeller Type - Non-Clog
• Impeller Material - Nylon
• Volute - Polypropylene
• Power Cord - 18/3 SJOW-A
• Mechanical Shaft Seal - Nitrile w/Carbon & Ceramic Faces
• Fasteners - Stainless Steel
• Shaft - Cold Rolled Steel
• Bearings - Upper: Sintered Iron/Copper, Flanged Sleeve.
• Bearings - Lower: Sintered Iron/Copper, Flanged Sleeve

Specification Sheet
Operations & Maintenance Manual