Air Scoop - Size 1-1/4 inch, used for air separation and air elimination in a water boiler / hydronic heating system. Piping connections are 1 inch FIP, the cast iron air scoop also includes standard tapings for fitting an expansion tank and automatic air vent.

Series RPV residential purge and balancing valves are used in heating applications on boiler return piping to facilitate removal of air from heating zones on initial fill and to control water flow through circulation loop. 3/4 Inch Purge and Balance Valve also serves as a shutoff valve and a drain valve for each zone or loop.

Aquastat Assembly for Beacon Morris Twin-Flo III Hydronic Kick Space Heaters. The 3024 is the Standard higher temperature Aquastat. Note: This is a repair part, a standard aquastat is an included component of all Twin-Flo Kick Space Heaters by Beacon Morris.

Beacon Morris Surface Mount Cabinet. Twin-Flo III Surface kits install quickly and easily — directly to a wall surface. Surface Mount Cabinet Heaters add warmth to hard to heat areas like breezy hallways, cold bathrooms, existing spaces and additions. Beacon Morris Surface Mount Cabinets are Cameo White, and have a new sloped top and rounded edges for a neat appearance. **(Cabinet (only) Heater is not included.)**

Bare feet, cold floor? Now you can warm your toes and have a warm comfortable room too - with Twin-Flo, Hydronic Heating Kick Space Heaters by Beacon Morris! Discreet heat, that's easy to use for most hard to heat situations. Use Beacon Morris units under bath & kitchen cabinets, under stairways and the floor mount model works between floor joists. There are surface mount & recessed in-wall models too. Twin-Flo III Kickspace Heaters are hydronic heating solutions that are built to solve most hard to heat problems. Beacon Morris works in all the right places - cozy, quiet and warm.

2 1/2" x 1/4" CBM ( Center Back Mount). A Tridicator is a gauge designed to measure temperature & pressure in a hydronic boiler.

DT-2 Drain-O-Tank® Air Charger by Bell & Gossett offers a sure, quick way to recharge a water-logged compression tank. Application the DT-2 Drain-O-Tank® Air Charger is use within a hydronic heating system in a non-diaphram type expantion tank.

Hydronic Temperature / Pressure Gauge. Gauge Face Size, 3-1/4" with 1/2" NPT Male straight pattern shank. This Temperature and Pressure Gauge is designed for use with a "Water Boiler", (a Hot Water Heating System). (Wal-Rich Part Number: 1711009).

Boiler Safety Relief Valve for a water boiler, 3/4" FIP Inlet x 3/4" FIP Discharge - 30 PSI, 550,000 BTU. When it comes to Safety Relief Valves, Think APOLLO by CONBRACO!

The Hydrotrol (HT) flow control valve is used to prevent overheating of zones due to gravity flow in hydronic heating systems. Available in 3/4", 1" and 1-1/4".